I've Found The Perfect Litterbox!

[Cinder & Smoke]

One thing I would suggest to you that I do is I use duct tape where I cut the hole
to make sure there are no sharp edges exposed to scratch or hurt them..

Another Hole Padding idea:

Go to a Plumbing Shop and ask for rubber or plastic TUBING that is about
3/8" to 1/2" in diameter - long enough to stretch around your opening.

Use a knife or a sharp, pointy scissors to cut through one side of the tube -end to end.
Slip the slit over your cut edge = a Padded Entrance!

[GILL]

Sorry but I would not suggest the tubing as I tried that. I put it on and the next morning I would step on it. Almost fell and broke my neck. I tried several types of glue, none would work. As a model builder I have over 14 glues in the house. The only one that came close was a hot glue, that lasted 2 days.

[Logan]

Sure would like to see a picture Avajoy! I am dealing with litterboxes again after 17+ years of not needing one (Butter and precious Mimi always have used the great outdoors). Henry and Bo make HUGE messes.

[AvaJoy]

I'm going to attempt to add two pix of one of the litter boxes. Hope it works 'cos i'm not familiar with doing this stuff!

My husband said he used a drill to mark the four corners, then a metal cutting blade to cut out the entry/exit.

[GILL]

Box looks good. Our is just a "U" opening. We have several boys that are too large to have the lid on.