I posted this on another forum I go to, where the people asked how I taped/braced the puppies ears... so thought I'd post it here too...

Here are step by step pictures of taping ears... sorry about the poor quality of pictures, its hard to tape ears, hold the puppy and take pictures at the sametime... but it should basicly show how I tape ears..

First.. you need your supplies... here is what I use.


Elastikon tape, starter fluid, rubbing alcohol, cotton cleaning pads to clean the ears.. and after I get the ears taped up, I usually stray something on the ears, to try to keep pups from pulling on eachothers braces..

Step 1:

unroll the amount of tape you will need.. this depends on the size of the puppy and the age of the puppy. If you are just bracing ears on a young puppy for the first time (6-7-8 wks old), you want the ears to be fairly close together on top of the head... otherwise you may end up with wide set ears.



Step 2:

Cut the tape in half.. if you use elastikon tape, I usually cut along the line that runs down the middle of the tape (for the 3 inch x 2.5 yards roll)



Step 3:

After you have cut the tape in half, you take one half of the tape and cute out the brace that will go from ear to ear. Then you take the other half of the tape and cut it in 2 long strips which will eventually be used to tape the tips of the ears down.



Step 4:

After you have cut the ear brace and the strips to later tape down the ear tips you can spray the back, sticky side of the tape with the engine starter fluid.. and let it sit for a few minutes. I would highly recommend spraying the engine starter fluid outside. After you sprayed the braces, you can go back to the puppy and clean out his ears really good with the rubbing alcohol. Make sure you get all the oil off the ears and then let the ears dry really good before you start the taping process...

Taping...

Step 1:

By now the tape should be very sticky and the engine starter fluid should be dry. You put one end of the ear brace in the first ear..... as shown in the picture below.. I personally like to stick the tape low in the ear, and toward the inside edge of the ear.. which you can see from the pictures..



Step 2:

Then you put the other sticky side of the brace in the other ear... so it looks like this.. here are 3 pictures to show you what it should look like after bracing both ears together...







Step 3:

Now this is where those other 2 strips of tape you cut into play.... you take one strip of tape and place in long ways, up and down the ear.. starting with one end right on top of the brace you just put in the ear.... and placing it all the way up the ear.. so the end of the tape sticks out above the tip of the ear... as seen below in the picture..